What's new! (27)

The 10mm Shims for 12mm Fork Legs are adjustment spacers used to compensate for misalignment, correct alignment, or adapt the mounting of 12mm diameter fork legs. They allow for correct...

The Steering Fork Bearing is the steering column bearing that allows the front fork to pivot freely and precisely within the frame. It supports the vertical and axial loads generated...

The Honda Dio/Elite/Ruckus Brake Lever Set is a set of brake levers designed to operate: a cable brake (usually rear), a hydraulic brake (usually front), depending on the scooter's original...

This Honda-type GY6 ignition coil converts the low voltage supplied by the AC CDI into the high voltage required to create the spark at the spark plug. It is a...

The GY6 light resistor is an electrical resistor used in lighting circuits to simulate an electrical load. It is primarily installed when original bulbs are replaced with LEDs, to ensure...

The Clutch Bell R-Vent 125 mm is a ventilated aftermarket performance clutch bell designed for scooters equipped with GY6 125cc to 150cc engines, including models such as the Honda Ruckus...

The clutch bell is an essential mechanical component of the CVT transmission in scooters equipped with GY6 125cc to 150cc engines, such as the Honda Ruckus GY6 and other scooters...

Le Clutch Spring +2000 rpm est un ressort d’embrayage centrifuge aftermarket conçu pour les transmissions CVT de scooters équipés de moteurs GY6 (125 cc – 150 cc), ainsi que pour...

The Clutch Spring +1500 rpm is an aftermarket centrifugal clutch spring designed for use in the clutches of CVT transmissions on scooters equipped with GY6 125–150 cc engines, as well...