What's new! (690)

This Naraku alternator rotor puller is a dismantling tool that allows you to remove the flywheel (rotor) from the crankshaft without impact or leverage. It is used by externally screwing...

The GY6 light resistor is an electrical resistor used in lighting circuits to simulate an electrical load. It is primarily installed when original bulbs are replaced with LEDs, to ensure...

The 12V flasher relay controls the flashing pattern of the left and right turn signals. It cyclically interrupts and restores the electrical current to produce the visible flashing of the...

The GY6 adjustable AC CDI is an ignition control module that allows manual adjustment of the ignition timing. It receives AC current from the stator, processes the signal from the...

The NCY Performance AC CDI is the ignition management module. It receives the AC current produced by the stator, interprets the signal from the pickup coil, and controls the precise...

This NCY direct ignition coil transforms the low voltage supplied by the AC CDI into high voltage and delivers it directly to the spark plug, without an intermediate high-voltage wire....

This 11-coil, three-phase stator is the internal electrical generator of the GY6 125–150cc type 157QMJ engine. It converts the mechanical energy of the crankshaft into alternating current (AC) for: powering...

The rotor for an 8-coil alternator is the main rotating component of the alternator on GY6 125cc to 150cc engines (e.g., Honda Ruckus GY6, Kymco, SYM, PGO, and other GY6-based...

The Taida Gearbox Bushing Set is a set of bushings designed for the internal mechanical support points of the secondary transmission/gearbox of scooters equipped with GY6 125-150cc engines (e.g., Honda...